*
Shelagh McNallyPosted top top February 14, 2012Posted in barisalcity.org, Rear forecast TV lamp Replacement—5 comments ↓

Mitsubishi WD-60735 TV


When the snapshot on her Mitsubishi becomes dimmer the time to change the lamp. You’ll should purchase a Philips Mitsubishi 915B403001 lamp replacement.

You are watching: How to change the bulb in a mitsubishi dlp tv

If you have a Mitsubishi collection WD-60735, WD-60C8, WD-65735, WD-65736, WD-65835, WD-65C8, WD-73735, WD-73736, WD-73835, WD-73C8 there will be a desk lamp Indicator ~ above the prior panel just left of the strength button.

When the TV is operating normally, this indicator will certainly not it is in lit. Once it turns RED, the Mitsubishi 915B403001 has reached its finish of life and must be replaced immediately; the TV will not operate with a scorched out lamp since this is the TV’s only light source.

The life the the Mitsubishi 915B403001 lamp deserve to vary depending upon the selected lamp mode and how lot the TV is used. The original lamp is guarantee from one year from the day of initial purchase.

Before Installation

Be certain to acquisition a genuine Mitsubishi 915B403001 desk lamp Cartridge (this includes the housing as well as the bulb) either directly from the manufacturer or from an authorized dealer. Cheaper models may damages your set since these space often developed with counterfeit, inferior components that will not right or do properly. Your warranty may also be void if you install a lamp bought native an not authorised source.

The Philips Mitsubishi 915B403001 lamp is the introduce cartridge for all Mitsubishi collection WD-60735, WD-60C8, WD-65735, WD-65736, WD-65835, WD-65C8, WD-73735, WD-73736, WD-73835, WD-73C8 televisions.

For one environmentally familiar and an ext economical option, friend can likewise just acquisition the bare lamp that allows you come re-use the existing housing by swapping the old pear for the new one. Read much more in ours Lamp replacement Guide.

Replacing the Philips Mitsubishi 915B403001 Lamp

CAUTION: Burn Danger! permit the T.V. To cool because that one hour prior to replacing the lamp. Avoid touching the desk lamp or lamp cartridge. Use the lamp handles just to remove the lamp.

HELPFUL TIP: use a pair the rubber gloves throughout installation. The Philips Mitsubishi 915B403001 desk lamp lamps does contain mercury, i m sorry may finish up on her skin. Don’t touch the desk lamp glass v bare hands together the oil kind your finger may cause premature lamp failure.

PART ONE: remove the Old Philips Mitsubishi 915B403001 desk lamp Cartridge

Turn turn off the TV and permit it come cool for one hour.After TV has cooled, remove the cover of the desk lamp compartment, located at the back of the TV. Utilizing a #2 Philips screwdriver, ease the screw hold the cover in place. Put the cover to one side.Loosen the two screws ~ above either next of the lamp cartridge (they room the shiniest screws). These screws deserve to only it is in loosened and also not removed totally from the desk lamp cartridge.Take the end the bag supplied with your new lamp and open it up. You’ll store the old lamp in this bag.Put the old desk lamp gently right into the opened up bag. Close the bag.

PART TWO: installing the New Philips Mitsubishi 915B403001 Lamp

Do a last wipe through a clean, non-abrasive, lint-free fabric to eliminate any feasible dust. Insert the new cartridge right into the TV there is no tilting the lamp. The desk lamp cartridge have to slide in easily.Gently tighten the two shiny screws. AVOID over TIGHTENING together this will cause a warning light and also your TV will not turn on.Replace the plastic cover and tighten the one screw. Again, stop over tightening.If girlfriend haven’t supplied gloves while transforming the cartridge: WASH her HANDS immediately. If friend did use gloves, dispose of castle immediately

PART THREE: handle of the offered Philips Mitsubishi 915B403001 lamp cartridge

Contact your regional recycling facility or Recycle your Lamp.org for help in recycling your old lamp.

PART FOUR: setting the lamp mode

You can extend the life of your Philips Mitsubishi 915B403001 lamp by transforming the lamp mode.

Using the TV remote push MENU.Scroll down to pick the collection UP menu. A top menu will appear.Scroll across the top food selection to the ENERGY option.Scroll down to the LAMP MODE choice on the right hand side. You’ll have the an option of STANDARD or BRIGHT.The STANDARD option is suitable for most viewing conditions and since it supplies a lower wattage can prolong the life of your lamp.

See more: Bc Powerpoint Ch A Graphic Representation Of Numeric Data Chart A Type

BRIGHT mode is perfect for brightly lit rooms however uses much more wattage and may alleviate the life of your lamp. Using this mode makes the TV hotter and also he fan might turn on an ext frequently.

Mitsubishi TVs Compatible through the Philips Mitsubishi 915B403001 Lamp

C Series: WD-60C8, WD-65C8, WD-73C8735 Series:WD-60735, WD-65735, WD-73735736736 Series:WD-65736, WD-73736835 Series: WD-65835, WD-73835C9 Series: WD-60C9, WD-65C9, WD-73C9737 Series: WD-60737, WD-65737, WD-73737, WD-82737837 Series: WD-65837, WD-73837, WD-82837