JavaScript is disabled. For a better experience, please permit JavaScript in her browser before proceeding.

You are watching: How many quarts of transmission fluid in a 700r4


*

I"m said the 700R4 holds around 11 quarts the fluid.My transmission builder says, "Put 6 quarts in the tranny, operation it for about 10 seconds, then include 5 quarts and run it again."Just spring for 2nd opinions.... Is that the best way to carry out it ???????
68 !!! Damn, if I had actually known ns was going to live this lengthy I would have taken better care of my human body !!
*

Did girlfriend put any fluid in the converter before installing it? I try to put in a qt or two and install the converter,, the is a great way her tranny male said, just dont operation it dry, matty man
*

I"m called the 700R4 holds around 11 quarts of fluid.My transmission builder says, "Put 6 quarts in the tranny, run it for around 10 seconds, then add 5 quarts and run it again."Just feather for second opinions.... Is that the best means to execute it ???????
It"s more than likely going to take around 12 qts without the deep pan. Placed in 5 qts, have all your bottles of fluid open. You don"t desire to it is in fiddling approximately opening party of liquid while it"s running. ~ the 5 qts, begin it up, add the liquid as it"s running. The trans have the right to suck the up much faster than girlfriend can include the fluid, therefore don"t hesitate to just bad them every in right away. Get 11 qts in it, then go inside and also put it right into every gear a couple of times. Include a bit at a time ~ that till it"s at the around the lower finish of the 2 lines on the stick. Go journey the car. Once you get back recheck and also fill to the full mark. You don"t desire to go to the full mark appropriate away because if you execute it might end up being overfilled as soon as it heats up as result of expansion of the fluid.
Mikehttp://www.mikes-transmissions.com/http://www.barisalcity.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
*

I didn"t even think about a dry converter, because the persons we get are pre-lubed. If yours looks dry inside, climate by all means add a qt come it.
Mikehttp://www.mikes-transmissions.com/http://www.barisalcity.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
*

I most likely screwed this up...Prior to installing the converter ns attempted to pour some liquid in yet was just able to obtain in small over 1/2 a quart... I probably was not doing the right.Now whatever is installed consisting of the dust cover.Can I run it together is or do I need to get an ext oil in the converter and also how is that best accompolished?Thanks !!
68 !!! Damn, if I had actually known ns was going come live this long I would have actually taken better care of my body !!
You"ll be fine with a half a qt. Don"t worry around it. I know shops that operation dry ones and say they don"t have problems. Many converters the don"t have some oil in them in ~ least have actually assembly lube, therefore they truly aren"t dry.
Mikehttp://www.mikes-transmissions.com/http://www.barisalcity.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
Just a reminder when you go for that test drive, simply take it easy, no pedal to the floor starts. I recognize I don"t need to tell you however sometimes I often tend to acquire excited and drop the hammer first time out. :smileyb:
It"s most likely going come take about 12 qts without the deep pan. Placed in 5 qts, have all her bottles of fluid open. Friend don"t desire to it is in fiddling about opening party of fluid while it"s running. After the 5 qts, begin it up, add the fluid as it"s running. The trans have the right to suck that up faster than you can include the fluid, therefore don"t hesitate to just bad them every in appropriate away. Obtain 11 qts in it, then walk inside and also put it right into every equipment a few times. Add a bit at a time after ~ that until it"s in ~ the around the lower end of the 2 lines on the stick. Go journey the car. As soon as you get earlier recheck and fill come the complete mark. Girlfriend don"t want to go to the full mark appropriate away since if you perform it might come to be overfilled as soon as it heats up as result of expansion the the fluid.
where did you gain the infor because that 12 Qts ???? I have a 700r4 just asking never ever put 12 in this one stock pan ( I included the Drain) smaller 9 1/2 inch converter 2500 /3000stall simply asking :dontknow:
Where go you obtain the infor for 12 Qts ???? I have actually a 700r4 simply asking never ever put 12 in this one share pan ( I included the Drain) smaller 9 1/2 customs converter 2500 /3000stall simply asking :dontknow:
That"s what go in it v a standard dimension converter. I more than likely should have actually asked what diameter converter he"s using. We"ve rebuilt and also installed literally numerous these in the 23 years I"ve been open. Check out mine website http://www.mikes-transmissions.com/. I"ve to be rebuilding trannys for 34 years, an owner because that 23. If you want to watch who ns am, click the YouTube video link top top the website. I"m the man in the start of the video. It also shows a couple of shots that the shop, among my techs and also customer testimonials.
Mikehttp://www.mikes-transmissions.com/http://www.barisalcity.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
My wife"s auto with the 700 calls the end 21.6 pints capacity, because that overhaul, so just under 11 quarts........
My wife"s auto with the 700 calls the end 21.6 pints capacity, because that overhaul, so simply under 11 quarts........
What sort of auto is it? A 700 behind a V8 with a full size converter take away 12 Qts. OK, provide or take a 1/2 a Qt. That"s why I just said to walk all the method to 11 then add as necessary. However you far better have 12 qts there or you"ll be quick on fluid.
Mikehttp://www.mikes-transmissions.com/http://www.barisalcity.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
I am making use of the Precision industries unit (2600 rpm)I think it"s 10" diameter.It"s the very same unit Kerno"s operation behind the 540 large block.Arnie
68 !!! Damn, if I had actually known i was going come live this lengthy I would have actually taken far better care the my human body !!
Well, her trans will take much less fluid. Placed in 5 qts, start motor, walk to 9 qts(including the 1/2 you placed in the converter)and begin checking the stick. If girlfriend don"t watch anything on the stick in ~ all add another qt. Don"t connect it till you see fluid on the stick. Engage it a few times into all the gear positions then add as necessary to acquire it ~ above the reduced line top top the stick(cold mark). Go for a check drive and also when girlfriend return recheck and include as essential to the higher line(hot mark).
Mikehttp://www.mikes-transmissions.com/http://www.barisalcity.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
The infectious diseases world fashion is not going to be very fussy around the liquid level. It have the right to be a quart low and work. Gift over complete can be much more of a problem. Obtain it close, journey it until it is warm and also check it in neutral with the engine running. Include fluid to suit.
Mike, my wife"s auto is a "93 Caddy Fleetwood RWD ( over-dressed Caprice) i was quoting the business manual because that the capacity.

See more: 2000 Nissan Altima Crank Sensor Location, 2000 Nissan Altima Camshaft Sensor


Bill, her wifes vehicle must have a slightly smaller sized converter. 12-14 qts is what we placed in relying on pan depth because that 4L60(700), 4L60E, 4L65E with complete size converters(12 inch).
Mikehttp://www.mikes-transmissions.com/http://www.barisalcity.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
Yeah Mike, that might be the reason.I to be wondering if the transmission might be somewhat various in a car with the trailer package ?? that does have actually a 3.73 behind end. To be wondering if the trans may be a heavy duty type, if over there is together a thing (?)
Bill, It most likely does have actually at least an outside cooler included to the system and maybe different accumulator springs in it because that an ever before so slighty firmer shift. Remember most Caddy owners intend a smooooooth change :>)
Mikehttp://www.mikes-transmissions.com/http://www.barisalcity.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352