JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.


You are watching: 2006 nissan altima crankshaft sensor location

Ok i obtained a 2006 altima 2.5l and also had to readjust the CPS sensor.. I might not find a good DIY so below you go, the damn STEALER want 300.plus to do this.. Hell through that... Eliminate the (4) allen head bolts that hold the plastic engine cover. Remove the waiting tube the connects the throttle chamber come air filter box. Pull turn off the valve covering breather hose with the wait tube. Now location a drop light under the two rubber heater hoses (at the firewall on the motorists hand side), glowing the irradiate forward towards the back side of the block (below the input runners). To check out the crankshaft sensor and connector, look in between the valve cover and the throttle chambers (intake runners) on the drivers side, look right down towards the ground… look for the sensor v a black color wire connector v a environment-friendly tab on the side, hosted to the engine block through a gold colored 10mm hex headed bolt. Friend will need to view the sensor indigenous this position as friend are complying with the steps listed below to remove and also install the crank sensor.
*

*

You will have to push ~ above the green component of the clip it rotates you below a CLICK. Then simply pull it turn off of the CPS. Mine just pushed in no prob, however if that is hard shot putting a 15mm socket on your ignorance and shot again so the wont reduced into your thumb it will certainly look prefer this once it come off.
*

Next action is to gain the CPS out of the side of the block, this to be the hardest component for me.. Its a 10mm bolt holding the in, i took a 2in extension and also reached down and also put it on the bolt. Climate took a 4-6in extension and also rachet and also hooked to the currently started 2in and socket and lossen that up.. Currently to gain the CPS out of the block you might be able to wiggle it back and soon to acquire it out, mine i took part needle nose pliers and grabbed it and pulled the out..
*

*



See more: Calories In Burger King Triple Whopper With Cheese And Bacon Calories

next come clean connectors and also put in brand-new CPS.. Lube increase the new O ring through oil slide it in the side of the block,,, then gain the 10mm bolt v the sensor and into the block, kinda tricky! and also torque it down think the is 8ft pounds mine is snug
*
" target="_blank" class="link link--external" rel="nofollow ugc noopener">If friend would prefer to Donate a dollar or two to me for this create up for saving you some cash, i would certainly be greatful... Simply click the connect below.. Thanks....https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=M2CXXRY436BWY