This overview discusses the typical problems that trigger the Dodge check engine light to remain on and also how come diagnose the difficulty yourself. 

What does Dodge inspect Engine LightEngine irradiate Mean?

*

If your Dodge check Engine LightEngine Light (CEL) is continuing to be on as soon as you start the car or come on while driving, it indicates that the On-Board Diagnostics (OBD) system has detected a problem.

You are watching: 2006 dodge dakota check engine light

A solid check engine light does not constantly mean one emergency, but it is necessary to have the codes check out as quickly engine irradiate does not constantly mean an emergency, but it is essential to have actually the codes review as quickly as possible.

If your Dodge inspect engine light engine irradiate is flashing, it way the ECU has detected one engine misfire. Execute not run your auto for prolonged period. Driving once the check engine is flashing can cause damage come the engine and also cataltyic converter.

Ignoring the CEL warning light can cause much more problems under the road.

Also, save in mind that your fuel economy may be lower if your Dodge CEL/MIL irradiate is on, and exhaust emission normally increases.

Your Dodge examine engine light can come on for various reasons. If it might be something as simple as a loosened gas cap, over 100 diagnostic trouble codes (DTC) can cause the examine eengine light can come ~ above for various reasons. If it might be other as straightforward as a loose gas cap, over 100 diagnostic trouble codes (DTC) can cause the examine engine lightengine light.

Without analysis the codes, it is impossible to know what is wrong. Below you will discover instructions on reading codes yourself or wherein you deserve to have them read for free.

Symptoms

Symptoms friend may an alert when her Dodge inspect engine lightengine light is on.

Reduced engine powerEngine shaking due to misfireReduced fuel economy

In part cases, you may not notification any symptoms except inspect the engine irradiate or service engine soon light top top the dashboard.

Most common Problems

*

Seven the the most usual problems that can reason the inspect engine light to which a evade engine light to which a Dodge auto are:

A loose gas cap or gas cap demands to it is in replaced.Intake vacuum leak

It is challenging to understand why her Dodge examine engine light is ~ above without analysis the faengine light is ~ above without analysis the error codes. 

What to do when the Dodge examine engine lightengine light come on?

If your Dodge inspect engine irradiate is on, in many cases, friend can continue to run the car if there space no power issues and also the examine engine irradiate is Nengine light is on, in many cases, friend can proceed to operate the car if there are no performance issues and the inspect engine irradiate is Nengine irradiate is no flashing.

 See the closestly mechanic or evade dealer if the check engine irradiate isengine light is flashing. 

1. Monitor Dashboard Warnings

Check her dashboard warning lights and also gauges. Make certain there are no warning lamp for low oil pressure or engine overheating.

Drive v caution and also continue come monitor how the auto is running. If the engine sound different, the difficulty may it is in serious and also should it is in diagnosed immediately.

2. Examine Gas Cap

Check your gas cap to make sure it is on tight. If you find that the gas lid was loose or removed, tighten it till you hear the click.

If you have a capless design, examine the flap for debris and make certain it closes properly. 

After a few driving cycles, the irradiate will turn off ~ above its own due to the fact that the ECU will keep on checking the EVAP system. 

It will certainly take a few driving cycles for the light to reset, and in most cases, the light resets within two to 3 days.

3. Screen Engine Temperature

Next, you have to monitor the engine temperature. If your check engine light came on due to the fact that of an engine misfire, the engine can be going engine light came on due to the fact that of one engine misfire, the engine could be going to overheat.

If the engine walk overheat, it can lead to a swollen head gasket, which can be a costly repair, particularly if your check engine light is flashing engine light is flashing or blinking.

If the engine is overheating or the oil light is ON, you have to pull over and also shut turn off the engine as quickly as possible.

4. Alleviate Speed and Load

If your inspect engine irradiate is on, mitigate your speed and also not unnecessarily load on the engine. If you are towing a trainer, either mitigate the speed dramatically or remoengine irradiate is on, minimize your speed and not unnecessarily load on the engine. If you are towing a trainer, either minimize the speed significantly or eliminate the load.

5. Check out Diagnostic problem Codes and also Reset check Engine LightEngine Light


Let"s look at at exactly how you have the right to use one OBD-II scanner to check out codes related check engine codes.

 

Turn on the ignition. It is not essential to start the engine if her Dodge has a Start/Stop button. Press it twice without pushing the brake pedal to rotate on the accessories and also the OBD-II port.Read dodge fault codes. Instructions on this action will vary depending on the scanner that you space using. For your convenience, us have noted videos ~ above using various OBD2 scanners to review codes and clear the Dodge inspect engine lightengine light.
*

Clearing codes without fixing the difficulty that triggered the CEL does not settle the problem. Always deal with the trouble first, then clear the examine engine lightengine light.

These instructions work on 1996 and newer dodge vehicles such together Dodge grand Caravan, Stratus, Viper, Challenger, Charger, Avenger, Caliber, Dart, Magnum, Neon, Durango, and also Journey.

How to read Dodge password without a scanner

For example, you can retrieve the password without a scanner top top a couple of Dodge vehicles such together Dodge Dakota and also Grand Caravans.

Cycle the an essential in the ignition 3 times. Turn vital to ON, then OFF three times.Leave the an essential in the ~ above position.Wait five seconds.

Dodge examine Engine irradiate FlasEngine irradiate Flashes 10 Times

If you rotate the an essential to the ON place (or crucial in ACC position) yet do not start the engine, you may notice the inspect engine light flashes 10x times. This happens if yengine irradiate flashes 10x times. This wake up if you newly disconnected the battery or provided an OBD-II scanner to clean the codes.

It way that one or much more of the emissions systems room not ready, known as the I/M readiness test.

All the solution will it is in tested as you drive the vehicle, and the light usually stops blinking after a few driving cycles.

If her Dodge CEL flashes 10 time at startup, proceed to drive your Dodge, and the light need to stop blinking within a couple of days. do NOT journey if the vehicle if the CEL continues to flash once the engine is running.

It is necessary to know that if her Dodge inspect engine irradiate is flashing 10 times, and you take it the car for an emission test, it will fail since at the very least one of the complying with systems iengine light is flashing 10 times, and you take it the auto for an emission test, it will certainly fail due to the fact that at least one that the complying with systems is no ready:

Fuel SystemCatalystHeated CatalystSecondary air SystemOxygen Sensor Sensor Heater

Even if your check engine light transforms off, yet one or more of these systems is no READY, your Dodge is not prepared for emissiengine light turns off, but one or an ext of these equipment is no READY, your Dodge is not prepared for emissions testing.

Once every the systems provided above room tested by the onboard diagnostic system and the auto is prepared for emission test, the examine engine light will certainly come on because that a couple of seconds then rotate off. It will not blink and should not continue to be on when the engineengine light will come on because that a couple of seconds then revolve off. It will certainly not blink and also should not remain on when the engine is running.

If you think the light is flashing 9 or 11 times, counting it again. It must blink ten times.

When you contact your evade dealer or any auto mechanic, you will be asked to lug the automobile for a diagnostic.

The factor is the they need to plug in a scan device to review the codes from the ECU. This is a procedure that you deserve to perform if you have the ideal tools.

For this checkup, dodge dealers charge between $80 and also $130. If her Dodge is quiet under warranty, your Dodge dealer will carry out diagnostic cost-free of charge.

Also, keep in mind that a few Dodge dealerships may offer cost-free check engine light engine light diagnostics.

Just analysis the codes is the beginning point. Your dealer will certainly make suggestions on the components that have to be replaced based upon the diagnostic results.

The main advantage of acquisition your auto to the dealer is that the dealership"s scanner provides much more detailed information than the password that girlfriend retrieve utilizing a share OBD-II scanner.

The diagnostic fee fee at the dealership or the mechanic go not encompass the expense to deal with it.

If you decide to have the car fixed at the same place that perform the diagnostics, questioning the manager to waive the diagnostic fee. In many cases, they will certainly if you ask in advance.

Fault Codes

While hundreds of Diagnostic problem Codes (DTCs) are few of the most usual fault password that numerous Dodge owners might experience.

P0456 

This code shows a very small leak in the EVAP system. A common problem v Dodge trucks such together Dodge lamb gasoline engine is a rotted hose for the EVAP system.

The hoses native the fuel tank come the engine deserve to crack over time. The trouble could additionally be the NVLD valve. Along with the P0456, girlfriend may additionally get P0440 or P0442. These space EVAP codes. If girlfriend have any kind of of this codes, inspect the gas cap together well.

P0456 & P0457

If the P0457 and also P0457 codes come up and also your examine engine light is on, the first you must do is to examine or even replace engine light is on, the very first you must do is to examine or also replace the gas cap.

*

If the code remains, there is a high chance that you have a defective leak detection pump. Her Dodge leak detection pump deserve to be accessed from under the car. It deserve to be changed without removing the fuel tank.

P0306, P0303 or P0300

These codes median that the Engine control Unit has detected an engine misfire. Any of the following can cause these codes:

*

Bad spark plugsDefective ignition coilFuel injector dirtyMass air flow sensorDamaged catalytic converterThese are just a few of the difficulties that can cause a cylinder misfire.

To identify the reason of P03XXX codes, you need to perform additional troubleshooting.

P1404

A defective EGR valve normally triggers this code. The EGR valve may have a negative solenoid or carbon blockage.

In many cases, the valve is replaced, i m sorry is a job that most DIYers can tackle themselves.

While the is no required, it is encourage to disconnect the battery while replacing the EGR valve. Friend can additionally clean the EGR valve, yet no guarantee clean it will solve the problem.

P0562

The P0562 code have the right to be motivated if a low device voltage is detected. Along with the P0562 light, you may also get a red battery warning light on the dashboard.

Newer evade vehicles might even go into a limp (fail-safe) setting when this code is present. Short voltage can be led to by a bad alternator or voltage regulator. It can also be caused by negative ground connection, corroded battery terminals, or a battery that has actually a poor cell.

If you review the codes and your Dodge has actually code P0562, address the problem as quickly as possible. If ignored, you may experience other troubles such as the engine refusing to start, negative fuel economy, or transmission not shifting out that Park and also into Drive.

P0404

If her Dodge check engine light is on and also you get code P0404, it meanengine irradiate is on and you acquire code P0404, it method that her Dodge Exhaust Gas Recirculation (EGR) valve is operation out that range.

The EGR valve intends to recirculate exhaust gases and send them earlier into the engine to lower the NOx emissions.

A new Dodge EGR Valve costs anywhere from $50 to $200 and is changed at the dealer top top average. You will certainly pay between $300 and also $550.

The EGR is placed on your Dodge engine near the exhaust. In many Dodge vehicles, the is relatively easy come replace.

This is a task that many DIYers deserve to perform in their driveway as long as you have actually the correct tools.

Keep in mind that the EGR valve itself may not always be the problem. The difficulty could likewise be the signal indigenous the EGR valve to the engine ECU.

This password has comparable symptoms to a vacuum leak as well. Make certain to examine the solenoid operation and also wiring as well. You should perform a continuity test on the wire harness come ensure the cable harness to the EGR is not defective.

Some the the most typical symptoms the the P0404 on evade vehicles incorporate engine dying at idle, engine stalling, or unstable idle. This is a usual problem on evade trucks such together Rams, wherein in addition to the P0404 code, friend may additionally get the P0406 code.

P0720

A P0720 code is a generic transmission code. The code indicates that there is a break down of the output column sensor. The problem could be the sensor itself or the wire harness.

Common symptoms include delayed shifting and the check engine light on. In part cases, a evade P0720 can additionally be resulted in by a defective transmission fluid temperaengine light on. In part cases, a dodge P0720 can also be brought about by a defective transmission fluid temperature sensor.

The sensor is mounted on the side of the transmission towards the end. Note that the output rate sensor is likewise used together the input rate sensor on certain Dodge transmissions.

Check the existing price top top the Dodge output rate sensor.

P0420

If your check engine light is on and you acquire the P0420 code, it means that the catalytic converter works belowengine light is on and also you obtain the P0420 code, it means that the catalytic converter works below efficiency.

In many cases, the catalytic converter is the culprit, yet the difficulty could likewise be one oxygen sensor not functioning prosensor not functioning properly.

One symptom of being a poor catalytic converter is the the car may struggle to accelerate once you press the gas pedal. Once this code is present, the fuel economic climate decreases.

See more: What Process Is The Cause Of Groundwater Erosion By Groundwater

P0441

This code method the evaporative emission regulate system has incorrect purge flow. A P0441 code on evade vehicles is regularly triggered by either a faulty purge control valve, purge solenoid, or damaged solenoid wires. This trouble can be caused by restrictions on the EVAP device or a negative vacuum switch.